The DMS Series - Digital Music Integrated Amplifiers are the most flexible and fully adaptable amplifiers available to today’s Modern Systems Integrator. Only PASO offers the following standard capabilities to make this amplifier customizable to a myriad of Professional and Commercial applications.
Inputs 1 - 5 are set as Microphone Inputs. Impedance
is 250 ohm balanced. Input 4 can be switched to AUX 1, Input 5 can
be switched to AUX 2 (internal jumper). Impedance is 47 K ohm.
Phantom Power is provided on all 5 Inputs.
Stereo Summing - Two separate RCA Jacks are provided for
Input 4 and 5 (Left and Right). A Stereo signal connected to
either Input is buffered and internally summed to Mono.
Input 4 & 5 Attenuators - When the Inputs are set as AUX 1 and
AUX 2 the input sensitivity may be varied by a rear panel Variable
Attenuator. This feature allows to set the output level of Programs
originating from different sources (CD, Satellite Receiver, etc.).
Phone Paging - A separate input is provided to interface with a
Phone System. Input Impedance is 600 ohm, Transformer Balanced.
A level control is available on the rear panel.
Module Port - accepts standard plug-in module. Module
Level Control is provided on the front panel. See list of modules
available from PASO.
MIX BUSS - This Input/Output may be utilized to parallel two
amplifiers or as an input for a Microphone Mixer or other
audio source. When used as an Input the Amplifier Level and
Equalization Controls have no effect.
Line Out - 600 ohm, 1.5 Volt Line Output.
Remote Volume Controls - The AUX 1 Input Volume and the
Master Volume may be adjusted from a remote location.
Remote Volume Inputs utilize a 50K Pot and are immune to
Audio Interference (DC Operation).
Addressable Dual VOX System can be individually selected to operate independently on all 7
Inputs by means of jumpers . Any Input may be set to activate
either VOX 1 or VOX 2.
Addressable Dual Muting System
can be individually selected to operate independently with all
7 Inputs by means of jumpers . Any Input may be set to activate
either MUTE 1 or MUTE 2.
MUTE 2 Adjustable Delay - A rear panel control adjusts the
MUTE 2 Time Delay (the time the MUTE 2 stays activated)
from 3 Sec. to 30 Sec. Particularly useful to control the
length of time that an Input mutes another (for example AUX
1 over AUX 2).
NO/NC VOX Relay is activated each time the
VOX or the Muting functions are turned-on. Three terminals
provide Normally Open and Normally Closed Contacts.
Music on Hold - Output Channel 1 - Channel 1 provides a
1 Volt, 600 ohm balanced output and a 1-Watt, 8-ohm output
for Music/Message on Hold or Zone 1 Speaker Output.
Internal Jumper selects the source from either AUX 1, AUX 2
or Input Module. Level Control is provided.
Output Channel 2 provides a 1-Watt, 8-ohm output
for Zone 2 Speaker Output. Internal Jumper selects the
source from either AUX 1, AUX 2 or Input Module. Level
Control is provided.
EQ LINK (Preamp Out) (Power Amp In) jacks are
provided for External Equalizer. Activated by the EQ Link
Tone By-Pass Switch defeats the
setting of the Treble and Bass Controls. Should be used
when an External Equalizer is utilized.
Subwoofer Outputs - Two independent Subwoofer Outputs
are provided a Pre-Equalization Output and a Post-
Equalization Output. Output Voltage is 1 Volt.
24 VDC Supply Output 250 mA regulated
Power Supply is provided for external accessories
- High Performance
- High Commercial Reliability Design
- Wide Frequency Response
- Very Low Distortion
- 7 Channel Inputs - 3 Zone Outputs
- 5 Balanced Microphone Inputs
- Phantom Power on all MIC Inputs
- MIC 4/AUX 1 and MIC 5/AUX 2 Inputs with Stereo Summing
- AUX1 and AUX2 Inputs Attenuator
- 600 ohm Transformer Balanced Telephone Paging Input
- MIX Buss and 600 ohm Line Output
- Independent Input Controls
- Accepts Standard Module
- Independent Module Level Control
- AUX1 and Master Remote Volume
- External EQ Link
- Tone by-pass and EQ Link switches
- Pre-EQ Subwoofer Output
- Post-EQ Subwoofer Output
- Addressable Dual VOX Buss
- Voice Activated Muting
- VOX Variable Time Delay Function
- Addressable Dual MUTE Buss
- Direct Muting and Un-muting
- 600 ohm and 8 ohm 1 Watt
- Music on Hold Amplifier
- MOH Amplifier Source Selector
- Zone 2 and 3, 1 Watt - 8 ohm Output with Separate Control
- NO/NC VOX Operated Relay
- 24 V DC 250 mA Regulated Power Supply Output
- 8 ohm, 25 Volt & 70 Volt Output
- 19” Rack Mounting Ready
- Low profile - 2-U of Vertical Rack space
- UL 6500 Listed (US - CANADA)