Lichtsteuerung : Dimmer & Dimmer Systeme : AMX - CCD-RS-277

277V Clear Connect Accessory Switch

Model: CCD-RS-277

Part #: FG2606-33-WH

Clear Connect Enabled – Lutron's patented RF Technology uses a quiet band, essentially free of interference ensuring reliable communication between system devices
Vacancy Sensing – Automatically turn off the lights and when integrated with RMS turn off electronic appliances off when a person leaves the space
Occupancy Sensing – Turn lights on when a person enters a room and when integrated with RMS automatically turns on electronic appliances in the room
Simple Web Configuration – Browse to the NetLinx® Clear Connect Gateway URL to quickly setup the Clear Connect Switch

Weitere Produktinformationen

Vergleichen

Projektliste

Produktinformation

Spezifikationen

OVERVIEW
The Lutron Clear Connect CCD-RS-277-WH is a 277V Accessory Switch that is used with CCD-8S-WH Clear Connect 120/277V Switches. The Switch when added to a Clear Connect System provides light control to virtually any location, without pulling wires.

Clear Connect Enabled – Lutron's patented RF Technology uses a quiet band, essentially free of interference ensuring reliable communication between system devices
Vacancy Sensing – Automatically turn off the lights and when integrated with RMS turn off electronic appliances off when a person leaves the space
Occupancy Sensing – Turn lights on when a person enters a room and when integrated with RMS automatically turns on electronic appliances in the room
Simple Web Configuration – Browse to the NetLinx® Clear Connect Gateway URL to quickly setup the Clear Connect Switch

Warranty - Yes

Operating Temperature (Maximum): 40 C
Operating Temperature (Minimum): 0 C
Zertifizierungen: UL, FCC
Wechselspannung: 277 Volts
Warranty (Length/Type): 3 Years Limited
Wattage (max capacity): 0.20 Watt
Power:
- Power: Power: 277 V 50 / 60 Hz
- Typical Power Consumption
  - Dimmer / Switch: 0.2 W
  - Test conditions: load is off and nightlight mode is enabled
  - Remote Dimmer / Switch: 0 W
  - Test conditions: load is off
- Surge Protection: To withstand surge voltages without damage or loss of operation, in accordance with IEEE C62.41-1991 Recommended Practice on Surge Voltages in Low-Voltage AC Power Circuits
- Power Failure: Power failure memory: should power be interrupted, the Clear Connect Gateway will return to its previous state when power is restored
Environmental:
- Operating Humidity: 0 to 90%, Non-condensing
- Indoor use only
ESD Protection:
- To withstand electrostatic discharge without damage or memory loss, in accordance with IEC 61000-4-2
COMMUNICATIONS:
- Dimmers and switches communicate with the system through Radio Frequency (RF) and must be located within 30 ft (9 m) of a repeater
- Remote dimmers / switches are not required to be within a specific range of a repeater. System devices operate on frequencies between 431.0 MHz and 437.0 MHz
Installation:
- Mounting Requires a U.S. wallbox. 3 . in (89 mm) deep recommended, 2 . in (57 mm) deep minimum
- Wiring Uses conventional 3-way and 4-way wiring
Connectors:
- 1 Ethernet port, 1 coaxial power socket
Certifications:
- CSA , NOM, IC, COFETEL

Find a Dealer

Find a Distributor

Suggested Products

0-10V 120V In-wall Dimmer, Almond Textured

by Crestron Electronics, Inc.

1-channel Green Light Switching Expansion Module with DALI Communication

by Crestron Electronics, Inc.

Cameo In-Wall Universal Phase Dimmer, 120 VAC, Almond Textured [Available 7/31/2020]

by Crestron Electronics, Inc.