Strommanagement : Stromsequenzen / Leistungsregelung : Furman - M-8S

15A Power Sequencer

Model: M-8S

Standard level AC protection and filtering
Six sequenced rear panel outlets (in 3 groups), two unswitched rear panel outlets, and one front panel unswitched outlet
Momentary and maintained sequencing via rear panel terminal block or front panel switch (momentary only)
All settings and configurations available on rear panel
15A rating

Weitere Produktinformationen

Vergleichen

Projektliste

Produktinformation

Spezifikationen

Dokumente

Merit M-8S power sequencer is the perfect low-cost AC power solution for any rack mount system. Install an M-8S in your rack, and the eight outlets in the rear panel will power up in sequence and protect all your equipment up to a 15-amp load. Six sequenced rear panel outlets (in 3 groups), two unswitched rear panel outlets, and one front panel unswitched outlet. Momentary and maintained sequencing via rear panel terminal block or front panel switch (momentary only). All settings and configurations available on rear panel.

Standard level AC protection and filtering
Six sequenced rear panel outlets (in 3 groups), two unswitched rear panel outlets, and one front panel unswitched outlet
Momentary and maintained sequencing via rear panel terminal block or front panel switch (momentary only)
All settings and configurations available on rear panel
15A rating
>26dB, 100kHz to 1MHz noise attenuation
225 Joules energy rating
Three years limited warranty

UL Rated - Yes
Warranty - Yes
Spec Sheet available - Yes

Zertifizierungen: C/CSA/US, UL
Schutzschalter: 15 Amps
Wirkleistung: 5 Watt
Tiefe: 222.25 mm
Height: 44.45 mm
Product Weight: 3.18 kg
Warranty (Length/Type): 3 Years Limited
Operating Temperature (Maximum): 40 C
Operating Temperature (Minimum): 5 C
Noise: >26 dB
Schnurlänge (in/mm): 3048 mm
Wechselspannung: 120 Volts
Shipping Weight: 3.63 kg
Line Cord: 14AWGx3, 10ft, black, fixed, NEMA 5-15P plug
AC Receptacles:
- Convenience Outlet (Front Panel) 1 Un-switched NEMA 15-5R
- Rear Panel Outlets: 2 Un-switched NEMA 5-15R (1 duplex)
- 6 Sequenced NEMA 5-15R (3 duplexes, each controlled by separate relay)
Standard level AC Surge Protection: Merit Class (sacrificial)
Spike Protection Mode: Line to neutral, zero ground leakage
Maximum Continuous Operating Voltage: 130 V (RMS )
Maximum Clamp Voltage: 500 V (Peak )
Peak impulse current: 12000 A
Energy Rating: 225 Joules
AC Filtering: Standard level Pi LCR Filter
Noise attenuation: >26 dB (100KHz to 1MHz)
Humidity Range: <90 % (Relative Humidity)
Rocker switch: Front panel, Sequence (ON, OFF)
Thermal Circuit Breaker: Front panel, push to reset
Front Panel Indicators: Delay 1, Delay 2, Delay 3, Power, Protection OK
Rear Panel DIP Switches: 12V Mode On/Off, GND Mode On, Momentary/Maintained
Potentiometer: Rear panel, time calibration fine tune delay adjust
Remote Terminal:

Power Sequencer 508 kb - Data Sheet

Projektliste

Power Sequencer 2980 kb - Other

Projektliste

Find a Dealer

Find a Distributor

Suggested Products

Xtend XPC Standalone Power Controller

by LynTec, Inc.

15A 2-pole Snap-on Motorized Circuit Breaker

by LynTec, Inc.

Load Center Circuit Breaker Panels with 40 RS-232 Controls

by LynTec, Inc.