Lighting Control Systems : Dimmers & Dimmer Systems : AMX - CCD-F6AN-DV-WH

6A Clear Connect Fluorescent Dimmer

Model: CCD-F6AN-DV-WH

10-band graphic equalizer on each output
Digital balance, tone and volume control on each output
Digital input gain control to normalize audio input voltages
Gold-plated RCA connectors
Standard RS-232 control port

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Related Products

Documents

Other Options

OVERVIEW

The Lutron Clear Connect 3-wire Fluorescent Dimmer is rated at 6A, requires a neutral wire and will control up to 60 ballasts. When added to a Clear Connect System the Dimmer provides light control to virtually any location, without pulling wires.

10-band graphic equalizer on each output
Digital balance, tone and volume control on each output
Digital input gain control to normalize audio input voltages
Gold-plated RCA connectors
Standard RS-232 control port
Supports AutoPatch's simple BCS serial control protocol
Optional TCP/IP control via external APWeb module
Ships with free APControl to provide easy single-user PC control of the matrix switcher
Ships with free AutoPatch GraphicEQ setup software
Rack mounting ears included
Backed by our AMX 3 year warranty

Warranty - Yes

Warranty (Length/Type): 3 Years Limited
Certifications: UL, FCC
Wattage (max capacity): 0.20 Watt
Operating Temperature (Maximum): 104 F
Operating Temperature (Minimum): 32 F
Current Draw: 6 Amps
AC Voltage (Minimum): 120 Volts
AC Voltage (Maximum): 277 Volts
Power:
- Power: Power: 120-277 V 50/60 Hz
- Typical Power Consumption
  - Dimmer / Switch: 0.2 W
  - Test conditions: load is off and nightlight mode is enabled
  - Remote Dimmer / Switch: 0 W
  - Test conditions: load is off
- Surge Protection: To withstand surge voltages without damage or loss of operation, in accordance with IEEE C62.41-1991 Recommended Practice on Surge Voltages in Low-Voltage AC Power Circuits
- Power Failure: Power failure memory: should power be interrupted, the Clear Connect Gateway will return to its previous state when power is restored
Environmental:
- Operating Humidity: 0 to 90%, Non-condensing
- Indoor use only
ESD Protection:
- To withstand electrostatic discharge without damage or memory loss, in accordance with IEC 61000-4-2
COMMUNICATIONS:
- Dimmers and switches communicate with the system through Radio Frequency (RF) and must be located within 30 ft (9 m) of a repeater
- Remote dimmers / switches are not required to be within a specific range of a repeater. System devices operate on frequencies between 431.0 MHz and 437.0 MHz
Installation:
- Mounting Requires a U.S. wallbox. 3 . in (89 mm) deep recommended, 2 . in (57 mm) deep minimum
- Wiring Uses conventional 3-way and 4-way wiring
Certifications:
- CSA , NOM, IC, COFETEL

ALD-CW-1 - 1-gang Claro Wallplate

ALD-CW-2 - 2-gang Claro Wallplate

ALD-CW-3 - 3-gang Claro Wallplate

Dimmer 2700 kb - Other

Project List

6A Clear Connect Fluorescent Dimmer

by AMX

Model: CCD-F6AN-DV

Find a Dealer

Find a Distributor

Suggested Products

Cameo® Wireless In-Wall Switch, 120V, Latte Textured

by Crestron Electronics, Inc.

Cameo In-Wall Universal Phase Dimmer, 120 VAC, White Smooth [Available 7/31/2020]

by Crestron Electronics, Inc.

8-channel Universal Dimmer Module, 2 Feeds

by Crestron Electronics, Inc.