The SBL-3000 is a 1300W power amplifier. It features three-positioned switch, stereo operates the amplifier as two independent channels, bridged bridges the two output channels for twice the output voltage and parallel is used for two or more amplifiers operating in-phase into common load. All SBL amplifiers are protected against shorted, open or mismatched loads, overloaded power supplies, excessive temperature, subsonic and ultra sonic phenomena. Switch up to disconnect the chassis from ground if necessary to eliminate hum caused by ground loops. Internal heat sinks and fan for rapid heat dissipation.
- Rotary level control, one for each channel
- Unit is turned on when button is pushed
- Flashes to show audio output in each channel
- Clip indicator
- Fault indicator is illuminated when amplifier goes into self-protection against destructive phenomena
- Switch to adjust input sensitivity to 0.77, 1V or 1.44V
- Switch to activate input signal compressor
- Switch up to disconnect the chassis from ground if necessary to eliminate hum caused by ground loops
- Stereo operates the amplifier as two independent channels
- Bridged bridges the two output channels for twice the output voltage
- Parallel is used for two or more amplifiers operating in-phase into common load
- XLR and 1/4-inch TRS balanced and unbalanced per channel
- High current binding posts (bridge mode) and Speakon type connectors per channel
- Resets circuit breaker that protects your power supply
- Internal heat sinks and fan for rapid heat dissipation
