hamburger-nav-icon
region-flag-icon
Search by Category
Audio
Cameras
Cases & Bags
Computers
Conferencing
Content Management
Control
Displays
Furniture
Lighting & Studio
Mounts & Rigging
Networking & Cabling
Power
Presentation
Production
Residential
Security & Safety
Signal Management
Search by Manufacturer
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
#
Search by Category
EnglishFrenchGermanItalianPortugueseSpanish
avpro-edge
Request
More Information
Project List
TECH TIP: CONNECTING & CONTROLLING THE FRESCO CAP 4
Posted on Tuesday, June 2, 2020
TECH TIP: CONNECTING & CONTROLLING THE FRESCO CAP 4

The Fresco 4 is a video wall processor able to handle 18Gbps 4K60 (4:4:4) through its 1 HDMI input and 4 HDMI outputs. Plug-and-play for a 4-panel video wall, or cascade multiple units for larger set ups.

The steps below outline how to connect and control the Fresco CAP 4 via the free PC software.

*Connection to displays is not required for setup

1.  Begin by setting a Device ID by putting down any of the first 4 dip-switches located on the fresco unit. To select a desired ID, simply refer to the table on the top of the unit.

2.  Download and Open the PC Software underneath the resource tab available here: https://www.avproedge.com/ac-fresco-cap-4.html

3.  Connect to the Unit using your connection of choice:

Network/LAN – Default IP Address 192.168.1.239 (for help adjusting IP Address, click the connection help button

RS232 – 3 Pin Phoenix

Micro-USB – May Require USB Driver available under the resource tab available here: https://www.avproedge.com/ac-fresco-cap-4.html

4.  Select the "Connect to Fresco" button, if connection succeeds you will receive a green CONNECTED status and the Device ID and Unit type will fill in with the corresponding information.

5.  Select the "Continue to Measure Page" button

6.  Enter the measurements (in MM) of the display into each of the info panels, If all panels are the same you may copy from Display 1. Flipped Panels MUST have their Top and Bottom measurements switched to avoid bezel compensation errors.

7.  Select the desired Output Resolution (Per Panel, 720p-4k60), then press the "Generate Video Wall" Button.

8.  To flip panels (if necessary) go to the Advanced Page and right click the desired output.

9. Lastly connect the Fresco to the Displays.

Output 1 = Top Left

Output 2 = Top Right

Output 3 = Bottom Left

Output 4 = Bottom Right

10. Viola, Your Video Wall is complete

Model: AC-FRESCO-CAP-4
Model: AC-FRESCO-CAP-4