CLS-EXP-DIMFLV enables the expansion of Crestron's iLux integrated lighting system and other Crestron lighting dimmers to enable control of 4-wire 0 to 10V fluorescent dimming ballasts. It can also be used to switch high-inrush loads such as motors, HID lighting, and non-dimmable fluorescents, as well as incandescent, low-voltage, and neon/cold cathode lighting. A single model supports 120/230/277V loads up to 16A. Any output channel of the iLux system can be used to control the CLS-EXP-DIMFLV to dim a fully loaded circuit. It is also compatible with CLW-series in-wall dimmers and select CLX-series lighting control modules. The metal enclosure is designed for mounting to a vertical surface. Conduit knockouts are provided on the bottom and lower sides. All connections are made via screw terminals behind the front cover.
Works with Crestron iLux, CLW and CLX series dimmers
Emulates the characteristics of the dimmer that is controlling it
Up to 5 expansion modules can be connected to a single iLux dimmer channel
Supports 120/230/277V incandescent, NCC, MLV and 2-wire dimmable fluorescent loads
Includes threshold adjustment for setting minimum fluorescent dimming level
Built-in air gap relay at the output
Surface mount design
Dimmer Channels:
1
Load Rating:
16 A
Minimum Load:
TBD
Dim Load Types:
4-wire 0 to 10V fluorescent dimming ballasts
Line Power Input Voltages:
120 to 277Vac, 50/60Hz
Control Input Voltage:
120/230Vac, 50/60Hz, phase independent of line power and load
NEUT Connections:
One captive screw terminal, neutral connection for control input
Hot Connections:
One captive screw terminal, line power input
Ground Connections:
One 3-terminal chassis ground bus bar
Load State Indicators:
One red LED behind front panel, illuminates when load output is on
Power Indicators:
One green LED behind front panel, indicates line power is applied to the hot terminal
Environmental Humidity:
10 to 90% RH (non-condensing)