The 1200T series Analog Clock Displays take master and slave clock technology to new levels of convenience and excellence.The clocks are microprocessor controlled and employ separate direct drive motors for each hand.This means that, as well as being able to set the time almost instantaneously, the new displays are also silent in operation.The hands of the clocks can be programmed to move in sweep mode or in steps.
Automatic detection of 30 Fps or 25 Fps SMPTE LTC timecode input
May act as an NTP client when +T option is ordered
Three motors for quiet operation and rapid hand setting - sets to time in 10s
Automatic Daylight Saving Time adjustment
Addressable slave clocks with programmable time offsets of 0 to 23.5 hours in 0.5 hour increments - set via DIP switches, RS-232 control or VistaLINK®
Accepts date information from LTC User Bits using SMPTE ST 309 or Leitch™ protocol
Master or Slave operation with battery backed up clock
Single cable distribution for both power and NTP using IEEE 802.3at Power over Ethernet
Optional back lighting of clock face
Two sizes 16"
Time may be set manually via pushbutton switches, or through the RS-232 serial port, or via VistaLINK®
Completely self-setting with NTP, (optioal) SMPTE timecode input or battery back-up
Built-in quartz time base oscillator with battery back-up
May be configured as a timecode generator to drive other clocks
Lighting brightness is adjustable
Powered by 12V DC (with 50/60Hz, 100 to 240V AC adapter), or IEEE 802.3at Power over Ethernet
10/100Mbit Ethernet port for NTP and SNMP control/monitoring with VistaLINK® Pro
AC Voltage:
240 Volts
AC Voltage (Maximum):
240 Volts
AC Voltage (Minimum):
100 Volts
Active Power:
12 Watt
DC Voltage:
12 Volts
Depth:
2.52 in
Height:
17.01 in
Width:
17.01 in
Product Weight:
10.50 lbs
Standard:
SMPTE ST 12-1 linear time code - 25 or 29.97 drop-frame Fps nominal
Connector:
Phoenix 4 pin terminal connector
Signal Level:
1V p-p nominal
Input Impedance:
> 30Kohm
MODE:
configurable as loop thru from input or output of local clock time
Accuracy:
< 2s per day with power on, no timecode present < 10s / day with power removed
Time Zone Offset:
0 to 23½ hours in ½ hour increments
Level:
RS232
Baud Rate:
57.6 Kbaud
Format:
8 data bits, no parity, 2 stop bits
Network Type:
Fast Ethernet 100 Base-TX IEEE 802.3u standard for 100 Mbps baseband CSMA/CD local area network
NTP Standard:
NTP v4 compliant, client mode support when +T option installed