The EQX-IP18FSAD-3G is an 18-channel EQX input module that can frame sync video, resample embedded audio and de-embed audio over the TDM bus. This module is designed to re-time a SMPTE 292M or SMPTE 259M input to a local reference signal. When necessary, frames are repeated or dropped to maintain synchronization.
The FSAD card not only supports eighteen (18) digital video inputs plus two (2) TDM inputs and (2) License-enabled TDM outputs, it also has an additional eighteen (18) DA outputs, that are looped from the synced signals that also feed to the passive DIN rear plate.
There are two more unique features that can be unlocked when specific licenses are applied: the EQX-FK-AE license to provide the ability of re-embedding audio from incoming TDM and the EQX-FK-DSP license that will provide the ability to set the audio delay independently from the video delay and adjust audio parameters such as gain, mixing two stereo pairs into monaural, invert and shuffle the channels and re-embed them into video or send them over TDM.
The EQX router can be loaded with a maximum of 32x FS modules providing square and non-square matrix configurations from as small as 18x inputs plus 2x TDM outputs and 2x TDM inputs through to 576x physical inputs, in increments of 18.
The EQX-IP18FSAD-3G is accessed from the front of the frame and can be replaced while the EQX router is operational. The rear plate is completely passive, and has 18x channels of adaptive cable equalization that can switched On/Off as required with software. These modules are air cooled by the fans mounted in the upper and lower half of the frame.