The Point Manager is an Ethernet gateway with an integrated data Web Server. The Point Manager can also be equipped with an optional 418MHz RF receiver or 900 MHz RF transceiver. It receives CRC-16 error-checked data packets from Point Six’s WiFi and RS485 sensors, processes the data, and makes the data available to be queried by simple ASCII commands or through dynamic HTML. The dynamic HTML can be viewed with any standard browser. The Point Manager communicates with a PC using TCP/IP or serial protocol. Simple ASCII commands are sent over the Ethernet using TCP/IP and/or RS232 serial port. The Point Manager contains a time of day clock, battery backed RAM, and flash programmable memory. It is fully configurable, both locally and remotely. It can store configuration information for up to 100 sensors having a combined maximum of 200 I/O points. The Point Manager was built with the flexibility needed to satisfy varied user requirements. There are several modes of operation that allow the user to balance simplicity, costs, precision, and timeliness. Monitoring - The easiest way to get information from the Point Manager is to view the current sensor values. This can be accomplished with a Web browser (no software coding required) or polling by a host. Both alarms and data are available. The dynamic HTML page displays on each row the following sensor information: name, serial number, age since last reception, service mode indicator, readings and units. All readings are shown in engineering units.