Pathway eDIN Contact Closure interface provides twelve DMX-controlled dry contact closures for both power and signal level switching. Multiple operating modes include momentary, maintained, 6-channel split and single channel select, where the DMX level of the start channel determines which relay is active. The eDIN #1003 provides DMX512 control over twelve form-C relays, for signal level switching, in a DIN-rail mountable format.
Each relay may be independently wired for normally-open (NO) or normally closed (NC) operation.
12 DMX controllable form-C switch closures
Momentary or maintained operation
DMX Present relay function
DMX level display
6-channel alternate mode
DMX-select mode, where DMX level corresponds to a triggered relay
DMX start address easily set
LED display and pushbuttons for configuration
2500V DMX input opto isolation
250V DMX fault protection
End-of-line termination switch
Status LEDs for power, DMX input, relay state
Pluggable screw terminals for all connections
DMX pass-thru connector
Snap-on DIN rail housing
DIN rail mounting section included
Relays rated for minimum 100,00 operations at 2A at 30VDC
1500V opto-isolation between input and output ports
ROHS Compliant - Yes
Operating Temperature (Maximum):
122 F
Operating Temperature (Minimum):
32 F
AC Voltage:
250 Volts
DC Voltage:
30 Volts
Height:
1.50 in
Width:
3.60 in
Product Weight:
1.54 lbs
ROHS Compliant:
Yes
Regulatory Compliance:
ANSI E1.11 DMX512-A(2008)/USITT DMX512(1990), ANSI E1.20 RDM(2010), ??CE/FCC, RoHS 2002/95/EC, Class 2 Low Voltage
Sustainability Rating:
Class 2
Relative Humidity:
10 to 90 %
Input operating voltage:
9 to 30 V DC
Opto-isolation:
1500 V
Power Consumption:
6 W
Length:
8 in
Relay Contact Rating:
2A per relay, at up to 30VDC