LED Dimmer modules provide DMX512 control over LED fixtures, with features such as user-definable MIN/MAX output, panic override, 0-10VDC auxiliary inputs and a "DMX present" relay. Smooth fading, absent from many DMX LED controllers, is assured with an integrated 2,000 step fade processor. Current-sinking control allows each output LED zone to operate at a different voltage. The DIN form factor makes installation, either in Pathway eDIN enclosures or your own cabinets, fast and easy. The 1008 eDIN is a dimming interface, independent of the LED fixture and its power supply. The 1008 will work effectively to dim any constant-current, non-dimming power supply feeding common-anode LEDs. LED fixtures should only be connected to the power supplies recommended by their manufacturers. The 1008 can also be used to drive components such as solid state relays and solenoid coils.
- User-set Grand Master maximum output
- User-set minimum output - even after loss of DMX
- 0-10VDC analog input auxiliary control
- DMX present relay
- Dry contact closure "panic" override input
- 6 DMX controllable variable DC outputs
- Output 5-30VDC (external supply required)
- Asynchronous 300Hz pulse width modulation
- Powerful fade smoothing to 2,000 steps
- RDM support for discovery, remote addressing, and firmware update
- LED display and pushbuttons for configuration
- 1500V DMX input opto isolation with self-resetting 250V fault protection
- 2500V isolation between all outputs protects against accidental grounding of fixture wiring
- End-of-line termination switch
- Status LEDs for power, DMX input
- Pluggable screw terminals for all connections
- DMX pass-thru connector
- Snap-on DIN rail housing
- DIN rail mounting section included
