hamburger-nav-icon
region-flag-icon
Search by Category
Audio
Cameras
Cases & Bags
Computers & Software
Conferencing
Content Management
Control
Displays
Furniture
Lighting & Studio
Mounts & Rigging
Networking & Cabling
Power
Presentation
Production & Lighting
Security & Safety
Signal Management
Search by Category
EnglishFrenchGermanItalianPortugueseSpanish
 

277V Fluorescent Dimmer

Model: SF-12P-277-3

  • Designed to operate in ambient temperatures from 0°C (32°F) to 40°C (104°F)
  • Allow a minimum space of 472" above and below the dimmer for proper heat dissipation
  • Energy saver lamps may not be used with this dimmer
  • With magnetic ballasts only, do not mix different wattage lamps in the same circuit
  • Greater dimming range is achieved by operating lamps at full intensity for 100 hours
Compare
Project List
Product Info
Tech Specs
Documents
Other Options
A single-gang wallbox (3" high x 2" wide x 272" deep) service all individual Skylark dimmers. These dimmers are designed to operate in ambient temperatures from 0°C (32°F) to 40°C (104°F). Allow a minimum space of 472" above and below the dimmer for proper heat dissipation. Energy saver lamps may Not be used with this dimmer. With magnetic ballasts only, do not mix different wattage lamps in the same circuit. Greater dimming range is achieved by operating lamps at full intensity for 100 hours. Use only dimming ballasts shown on chart in step 2 of pre-installation. Do not mix 1 and 2 lamp ballasts in any one dimmer circuit. Do not mix ballast manufactured by more than one company. Using single lamp ballasts produce the most consistent low end dimming level.
  • Designed to operate in ambient temperatures from 0°C (32°F) to 40°C (104°F)
  • Allow a minimum space of 472" above and below the dimmer for proper heat dissipation
  • Energy saver lamps may not be used with this dimmer
  • With magnetic ballasts only, do not mix different wattage lamps in the same circuit
  • Greater dimming range is achieved by operating lamps at full intensity for 100 hours
  • Use only dimming ballasts shown on chart in step 2 of pre-installation
  • Using single lamp ballasts produce the most consistent low end dimming level
 
 

Suggested Products

by Crestron Electronics, Inc.