Analog output wiring tester. Through the years we have found that when there is a problem with a system during installation, that most times an output wiring problem caused it. These testers can be used during a new installation or on any existing show to test for wiring problems.
The Tester-J6A card will plug in place of an analog output card (Br-ANA). The slide pots on the Tester-J6A sends 0-10 vdc control signals to simulate a Br-ANA.
- Sixteen slide pots simulate the 0-10 vdc analog output from a Gilderfluke & Co. Br-ANA
- Indicator LEDs clearly show the status of each analog output
- Any analogs that are shorted to their neighbor can easily be seen (two LEDs will move)
- Four ‘Power’ outputs on the J6/A connector are PTC circuit breaker protected
- Indicator LEDs clearly show each ‘Power’ output
- Any shorts on the ‘Power’ outputs are indicated by a red LED
- Output driver ICs are socketed for easy replacement in the event of a really bad miswire
- Runs on any voltage from 17 to 24 vdc, just like a Br-ANA
