Analog output wiring tester. Through the years we have found that when there is a problem with a system during installation, that most times an output wiring problem caused it. These testers can be used during a new installation or on any existing show to test for wiring problems.
The Tester-J6A card will plug in place of an analog output card (Br-ANA). The slide pots on the Tester-J6A sends 0-10 vdc control signals to simulate a Br-ANA.
Sixteen slide pots simulate the 0-10 vdc analog output from a Gilderfluke & Co. Br-ANA
Indicator LEDs clearly show the status of each analog output
Any analogs that are shorted to their neighbor can easily be seen (two LEDs will move)
Four ‘Power’ outputs on the J6/A connector are PTC circuit breaker protected
Indicator LEDs clearly show each ‘Power’ output
Any shorts on the ‘Power’ outputs are indicated by a red LED
Output driver ICs are socketed for easy replacement in the event of a really bad miswire
Runs on any voltage from 17 to 24 vdc, just like a Br-ANA